FH-U1 Film Strip Holder for Minolta DiMAGE Scan Dual III / IV

Replace a missing FH-U1-style film strip holder and bring your Minolta scanner back into use. This three-piece holder is designed for 35 mm film strips in the DiMAGE Scan Dual III and Scan Dual IV.

What you get

• One film-holder base
• One matching lid
• One retaining clip

Physical 3D-printed parts supplied in black. Film, scanner and additional hardware are not included.

Compatibility

Designed for Minolta DiMAGE Scan Dual III and Scan Dual IV. Compatibility follows the published design; MAYDE has not independently fit-tested this holder. Please check the model name on your scanner. Scan Dual II and DiMAGE Scan Elite models are not included in this compatibility claim.

Using the holder

Handle film by its edges and keep the holder clean. Position the strip in the base, close the lid and secure it with the retaining clip. Follow your scanner's film-loading instructions and do not force the holder into the scanner.

Material and finish

3D-printed polymer with visible layer lines. The finish may differ slightly from the illustrations. Made to order by MAYDE.

About this replacement

An independently made replacement, not an original Minolta product. Brand and model names identify compatibility only.

Design credit

Based on BOKEN4's FH-U1 version 2 design, derived from Hcompton79's version and RagingRiver's original, under Creative Commons Attribution-ShareAlike 4.0. Source geometry is unchanged; MAYDE created the image presentation. The design and adaptations remain under that licence.

Images

Images are model-based illustrations.