35 mm Film Holder for Epson V550 / V600 Scanners

Replace a missing 35 mm film holder for an Epson Perfection V550 or V600 scanner. This two-piece holder supports film during scanning.

What you get

• One 35 mm film-holder base
• One matching lid

Physical 3D-printed parts supplied in black. Film, scanner, magnets and adhesive are not included. The design has two strip channels and accommodates strips of up to five 35 mm frames.

Compatibility

Designed for Epson Perfection V550 and V600. Compatibility follows the published design; MAYDE has not independently fit-tested this holder. Check your scanner model before ordering. V500, 3170, 4490 and V700-series models are not included in this compatibility claim.

Using the holder

Handle film by its edges, keep contact surfaces clean, position the film in the base and place the matching lid over it. Follow your scanner's film-loading instructions. Do not force the holder into position. The design includes recesses for optional 6 mm diameter by 2 mm thick magnets. The designer states magnets are not required; none are supplied.

Material and finish

Black PLA, 3D printed with visible layer lines. Made to order by MAYDE. Keep away from heat and direct sunlight. Finished appearance may vary slightly from the illustrations.

About this replacement

An independently made replacement, not an original Epson product. Brand and model names identify compatibility only.

Design credit

Based on cudderbup's Epson V600 35mm, 120, and 110 Film Holders, licensed under Creative Commons Attribution 4.0. Source geometry is unchanged. MAYDE created the image presentation.

Images

Images are model-based illustrations.