Stitch Selector Knob and Cover for Husqvarna Viking 2000 / 6000

Replace a cracked or missing stitch-selector knob on a compatible vintage Husqvarna Viking sewing machine.

What you get

One printed stitch-selector knob and one plain clip-on cover, in black PLA. Shaft, spring, screws, metal mechanism, machine and tools are not included. Reuse the serviceable original hardware. The cover is plain, without printed stitch symbols or numbers.

Compatibility

Husqvarna Viking 2000 / 6000-series machines with the matching stitch-selector knob arrangement. Compare the original shaft fitting and the product views before ordering. Knob model is approximately 36mm across and 19mm deep; cover is approximately 31.8mm across. These are model dimensions, not measurements from a finished print. Compatibility follows the published design; MAYDE has not independently fit-tested this part.

Fitting

Remove the damaged knob following the machine service instructions, retain any original hardware and install the replacement knob; the separate cover clips onto it. Unplug the machine before work. A stiff or seized selector mechanism should be serviced first; do not force it with the new knob.

Material and finish

Black PLA, made to order by MAYDE with visible 3D-print layer lines. Appearance may vary slightly from the illustrations.

About this replacement

Independently made compatible replacement, not an original manufacturer part. Brand names identify compatibility only.

Design credit

Based on the published design by KR34T1V, under Creative Commons Attribution 4.0. Source geometry is unchanged. MAYDE created the image presentation.

Images

Images are model-based illustrations.