Miele combi dosing device flap

This detergent dosing flap is printed to order in heat- and UV-resistant ASA. It is the flap only – not the whole dosing unit – and is intended to replace a broken flap on the combi dosing device of your existing dishwasher.

What you get

• One replacement detergent dosing flap in black ASA.
• Flap only: the dosing unit, its spring and gasket, and the dishwasher are not included.
• The design is made to reuse your original spring and gasket – see FITTING below.

Intended for

The design is based on a flap made for the Miele combi dosing device C1.11 (220–240 V). Miele UK lists that dosing device for G 1xxx, G 2xxx, G 3xxx, G 4xxx, G 5xxx (up to 2017) and G 6xxx series dishwashers. We have not yet confirmed the fit on each model.

Fit on other versions of the dosing device has not been confirmed.

Check the fit

Check the type and part number labels on your dosing device, and compare your original flap, before ordering. If you are unsure, contact us with your dishwasher's model number and clear photos of the dosing device and the broken flap, so we can help identify what you need.

Fitting

Disconnect the dishwasher from the mains before you remove the dosing device: removing it exposes mains-voltage wiring. The flap is designed to reuse the torsion spring and gasket from your original dosing device. Please contact us before ordering if you need to know exactly what fitting involves. The flap works inside the wash cabinet with hot water and detergent, so check that it opens, closes and latches properly over the first few wash cycles, and stop using it if it warps or the spring no longer holds it.

Material & finish

Printed to order in our workshop in Great Dunmow, Essex. Black ASA, which is heat- and UV-resistant, is used for the flap. Fine layer lines are a normal part of the 3D-printed finish.

Made to order

Each flap is printed after you order. See the delivery section for the current dispatch estimate and postage options.

About this replacement

This is an aftermarket replacement, not an original Miele part. MAYDE is not affiliated with or endorsed by Miele. Brand and model names are used only to identify the intended application.

Design credit

Based on the design "Replacement Door for Miele Part No. 5919488 Dishwasher Combi Dosing Device" by Irgendeintyp on Printables, licensed GPL-3.0. Printed and finished by MAYDE.

Image & fit status

The gallery contains illustrative product renders for this listing. Final product appearance, measurements and physical fit are awaiting confirmation before release. The images do not demonstrate a tested installation.

Questions about the part? Get in touch with MAYDE.