Table clamps and clamp screws for Logitech G29 (pair)

This pair of replacement table clamps, each with its clamp screw, is printed to order in tough black PETG. They are intended to replace the plastic desk clamps on a Logitech G29 Driving Force racing wheel, which can crack or break under clamping force. The wheel itself is not included.

What you get

• Two replacement table clamps with their clamp screws, in tough black PETG.
• Clamps and screws only: the racing wheel, desk and any other mounting hardware are not included.

Intended for

The design is based on a table clamp and clamp screw made for the Logitech G29 Driving Force racing wheel. The designer made it to repair a broken G29 and has not tested other Logitech wheels. We have not yet confirmed the fit on each model.

Other sellers of similar printed clamps list the G25, G27, G920, G923 and Driving Force GT. We have not checked this design against those wheels, so please contact us before ordering if you have one of them.

Check the fit

Compare your original clamps and screws before ordering. If you are unsure, send us a message with your wheel's model and clear photos of the clamp area on the underside of the wheel base, so we can help identify what you need.

Fitting

These clamps hold your wheel to the desk under clamping force and force-feedback loads. Tighten them only enough to hold the wheel steady, check them regularly for cracks or loosening, and stop using them if you see any, as a failed clamp could let the wheel fall from the desk.

Material & finish

Printed to order in our workshop in Great Dunmow, Essex. Tough PETG is used for the clamps and screws. Fine layer lines are a normal part of the 3D-printed finish.

Made to order

Each pair is printed after you order. See the delivery section for the current dispatch estimate and postage options.

About this replacement

This is an aftermarket replacement, not an original Logitech part. MAYDE is not affiliated with or endorsed by Logitech. Brand and model names are used only to identify the intended application.

Design credit

Based on the design "G29 Clamp and Screw Replacement" by Buffalo on Printables, licensed CC BY 4.0. Printed and finished by MAYDE.

Image & fit status

The gallery contains illustrative product renders for this listing. Final product appearance, measurements and physical fit are awaiting confirmation before release. The images do not demonstrate a tested installation.

Questions about the part? Get in touch with MAYDE.